Polaris 7S Touch Display Screen Protector
Unique Performance LLC.
Polaris 7S Display Screen Protector Instructions
Step 1. Clean the 7S Display and make sure there is no dust or debris on the screen
Step 2. Remove residual bits of dust with a mild adhesive
-Dust is the most important thing to remove from under a screen protector: bubbles will eventually diffuse out through the plastic and finger marks will probably merge with the glue, but dust specks will stay.
-Lightly dab a sticky note or adhesive material all over the screen to ensure you’ve removed all dust from the surface. (Looking at the reflection of a bright area in the screen at an angle will confirm the presence or absence of dust)
Step 3. Stick on the screen protector, aligning an edge carefully
-Peel back the screen protector's backing from one end (leaving it on the other allows more control by holding that end). Align it with the correct edge of the screen, leaving the margin you determined previously and watching how the alignment of the sides perpendicular to it will fall. Then peel off the entire backing and smooth down the protector.
Step 4. Remove air bubbles
- Wipe the air bubbles toward the edges with a smooth implement like a credit card. Don't do this forcefully unless the screen protector has a surface protector to peel off after installation: the air will eventually diffuse out and too much force could scratch the brand-new protector.
Step 5. Enjoy your newly protected display!
Tips:
- If you need to reposition the screen protector, lift an edge carefully with a thin but not sharp implement like a piece of backing material, fingernail, or plastic spoon edge.
-Little mistakes like tiny dust specks should be ignored, as trying to fix them will do more harm than good
Copyright 2021 Unique Performance LLC.
www.uniqueperformancediesel.com